Please select To the mobile version | Continue to access the desktop computer version

zeusbtc bbs

 Forgot password?
 Sign up now
Search
View: 283|Reply: 0

How to Locate the Fault Part by the Error Code of the Miner?

[Copy link]

65

Threads

65

Posts

246

Credits

Moderator

Rank: 7Rank: 7Rank: 7

Credits
246
Post time 2021-11-20 10:02:00 | Show all posts |Read mode
Edited by Sophie at 2021-11-20 10:34

How to Locate the Fault Part by the Error Code of the Miner?
1. Download the batch management tool to the desktop and open it.
2. Input the IP range to which the miner belongs and click the "Scan" icon.
If the miner does have a problem, but the batch tool fails to report an error code, enter the miner log backstage to find the error code. The method is as follows:
3. Check the miner failure according to the error code and confirm the fault location.
Notice:
1. The miner shall be powered on again to see whether it becomes normal each time you perform one resolution step.
2. The replaced part shall be reinstalled on the original miner once again after replacing the part but with the default unsettled.
Error code
Problem Description
Suggestion
32
Over-temperature protection
① Whether the fan is usually working, and whether the rotation direction of the two fans is the same
② Whether the temperature of the air inlet of the fan is too high and move the miner to the lower position of the shelf
Notes: If the problem occurs massively, the abnormal miner temperature shall be taken as a top priority. (i.e. local fan failure)
30
Unable to connect to the mining pool
1. Some miners
① Check whether the pool is configured correctly
② Check whether the network port of the miner is tightly connected
③ Exchange network cables with normal
④ Replacing the control board
2. All miners
① Check whether the pool address is configured correctly
② Check whether the operator's network is interrupted
③ Check the local network setting (such as the setting of DNS, DHCP, ports, and other settings)
22、29
Battery 12C communication is abnormal
① Restart
② Replace the power supply, you can choose theLianli Small Steel Cannon PSU 2500W
③ Replace the control board
35、40、41
Abnormal power output
① Restart
② Replace the power supply
21
Individual hash boards are not detected
① Check the power supply and cable connection of the hash board and then plug it in again
② Put the faulty hash boards into one miner or several miners
Notes: The problem may be caused by setting up the miners and removing them off the shelf violently. Please consult the after-sales personnel before returning the faulty hash boards which are put together into one or several miners. Failure to do so many result in damage to the miner or delay in repairs.
34
The data cable connection sequence is incorrect
① Restart
② Check whether the data cable and power cable connection sequence are consistent
23、24、27
Hash board fault
① Power off and turn on the miner after cooling for 10 minutes
② Replace the hash board
Notes: Please consult the after-sales personnel before returning the faulty hash boards which are put together into one or several miners. Failure to do so many result in damage to the miner or delay in repairs.
25、26、28、33、36、42
Hash board fault
① No treating is needed if the hash rate is normal
② Replace the hash board
31
Individual chip abnormality
① No treating is needed if the hash rate is normal
② Replace the chip
37
The Control board or hash board does not match
Replace with the specific control board parts for this model of miner

ASIC Miner Repair Toturials and Guides
Reply

Use magic Report

You have to log in before you can reply Login | Sign up now

Points Rules

Privacy Policy Terms of Service
Quick Reply To Top Return to the list